|
|
Left: This is CXI's basic CO1 collar that is made to measure using either 3mm or 6mm steel. Comes with locking bolt and facility for locking with a padlock. The collar come lacquered and has 2 or 3 loops for tethering. Although you can specify where you want the tether loops to go. Please allow an extra few mm's for safety and comfort. |
|
Right: The CO2 pictured left are a excellent value for money restraint device. Can be used with either arms in front or rear of the body. The neck collar and wrist restraints are made to your own measurements and as with all CXI products they come with the standard lacquer and chain. All parts are lockable with the fixed bolt and there is provision for a padlock. Available in either 3mm or 6mm steel. The picture far left shows close up detail of a typical collar. Note these are not just bent bits of metal but eight individual parts welded together. You can also opt for neck to ankle, the CO4. This is also made to measure |
|
|
|
Left: Pictured left is the the ultimate in combination kits, the CO3 is fully adjustable and can be undone for various uses. All components are fully made to measure to your specifications. Photo courtesy of Armyskin off ICQ. Please make sure you allow enough room to breath and decide if you want the shackles to fit over a bare leg or boots. Right: Here is the much awaited CO5 spiked collar with long spikes that rearly do make a statement about your slave! Made to measure with 12 6" spikes this is bound to attract some attention. These are well over £90.00 in some shops in London so these are a bargain! |
